Craftsman Sun Shade 486.24226 - Manual (Page 5)

5
• Insert the upright tubes onto the right and left base
tubes, turning the upright tubes so that the small hole
shown in figure 4 faces inward. Fasten using two 1/4"
x 1-1/4" hex bolts (A) and two 1/4" nylock nuts (D).
See figure 4.
FIGURE 4
• Attach top tubes to the upright tubes, but do not
install mounting bolts at this time. See figure 5.
• Attach rubber caps onto the ends of both top tubes.
See figure 5.
FIGURE 5
• Unfold sun shade and locate the nylon loops found
on the mesh portion of the sun shade. The mesh is
located at the rear. See figure 6.
• Hold the sun shade in front of the top tubes and slip
the nylon loops onto the ends of the top tubes. Slide
the sun shade along the top tubes, inserting the ends
of the tubes into the stitched sleeves on each side of
the sun shade. Continue until the ends of the tubes
are pushed all the way to the ends of the sleeves.
See figures 6 and 7.
FIGURE 6
• Install the shorter support rod with the flattened
sections into the holes at the front of each top tube.
Slits in the stitched sleeves provide access to the
holes in the top tubes. See figure 7.
FIGURE 7
NYLON LOOP
SLEEVE
SMALL
HOLE
UPRIGHT TUBE
1/4" NYLOCK
NUT (D)
1/4" x 1-1/4"
HEx BOLT (A)
SUPPORT ROD
RUBBER CAPS
UPRIGHT
TUBES
TOP TUBES
HOLES ON
INSIDE