Tie Down 125 Actuator - Manual (Page 8)

TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336
www.tiedown.com (404) 344-0000 Fax (404) 349-0401
WARNING:
If the emergency stop bracket is towards the rear (shown in #2) , this indicates that the
emergency stop bracket is “set” and must be released before using the trailer.
Photo 1
Photo 2
Photo 3
Releasing The Emergency Stop
Emergency Brake Disengaged
- Normal Use -
Emergency Brake Engaged
- DO NOT TOW -
Emergency Stop Release Bracket
-Pry up to release Emergency stop-
To Release the Emergency Brake:
Pry up the emergency stop release bracket (located on the
underside of the actuator) with a screwdriver (Photo 3) until
the E-stop bracket snaps back into the disengaged position
(Photo 1).
Note: if you any reason you believe your brakes are
engaged, the release procedure can be preformed at any
time. Always make sure the release bracket is towards the
tow vehicle (Photo 1).