Tie Down Bunk Guides 24 - Manual (Page 2)

Heavy Duty Guide
On Post
Assembly Instructions Continued
*Heavy Duty Guide On Post with Lights
Wiring Instructions for Models 86441 & 86440
121311,a682
Instructions # 15344
TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336
www.tiedown.com (404) 344-0000 Fax (404) 349-0401
Front
Out
Figure 1
Upper Mounting Plate
Orange Bullet
Cap (Glued in place)
Red LED Guide
On Light*
Lower Mounting Plate
3/8” Nuts & Washers
Trailer
Running Light Wire
(Normally Brown)
Black Wire
(From LED Light)
Splice
Connector
Splice Plate
Support Tube
(Outside of Trailer Frame)
3/8”x 5” Bolts & Washers
2. Using 4 - 3/8"x 5" carriage bolts, 8 flat
washers and 4 nyloc nuts, for each,
attach the guide support mounts
onto your trailer frame, as shown in
figure 1. Use the holes that will keep
the bolts closest to the frame tube.
Finger tighten at this time. Repeat for
other side.
3. Slide the guide support tube into the
assembly as shown in figure 2.
4. Adjust the guide tubes for proper
distance on each side. Tighten support
mounts bolts at this time.
5. Side the PVC tubes over the metal
tubes.
1. Pull out the white and black wire from the bottom of the
PVC tubes. Straighten both lines to the full length.
2. Position the PVC tubes so the red light faces backward.
While holding the ends of both wires slide the PVC tubes
over the steel support tubes. The remaining wire should
extend below the tube and steel support tube.
3. Press the trailer running light wire (brown) into the open
side of the splice connector. Push the black LED wire
into the opposite side of the splice connector.
4. Place the splice connector in the pliers and press the metal
splice plate thru both wires. Close the locking tab.
5. Place the self tapping screw thru the eyelet on the white
grounding wire. Screw the self tapping screw into the
trailer frame.
6. Hook up the trailer and test your towing lights.
When the trailer/tow vehicle lights are on the red
LED lights should also be on.
Locking
Tab