Tie Down Jet Rail - Manual (Page 5)

7. Attach Bunks to Jet Rail Deck
Attach one swivel bracket on each "corner" of the Jet Rail
Deck as shown in Picture 9. There are several holes in which to
adjust the width of your bunk boards to fit your watercraft. We
recommend that you start with the outer most hole and adjust
inward if necessary. Tighten bolts enough to allow adjustment
of the bunks on your watercraft.
Attach bunk boards to the swivel brackets on each side of the
deck, with two 1-1/4" screws at each bracket. Bunks should be
mounted with one inch of overhang on the front swivel brack-
ets. After deciding on the permanent placement of the bunks
(picture 10), tighten all four bolts holding the swivel brackets
to the deck.
Parts required for this step.
# Stk. # Description Qty.
5 26609 Jet Rail Deck 1
18 86116 Swivel Bracket 4
27 BBB3750100 3/8" x 1" Hex Bolt 4
34 BBN375NL 3/8" Nyloc Nut 4
10 44816 5' Carpeted Bunk 2
25 10903 1-1/2 0" Screw 8
Position bunk boards evenly spaced
to fit on smooth surface of hull.
Watercraft Hull
Bunk Boards
Picture 10
18
5
Picture 9
8. Attach Keel Pads
Parts required for this step.
# Stk. # Description Qty.
11 17057 Keel Pad, 6" long 2
24 10904 Self Tapping Screw, 3/4" 4
Attach a keel pad in the center of each end of the Jet Rail Deck,
with the 3/4" long screws (picture 11).
Picture 11
11
5
Picture below shows bunkboard placement