Tie Down Slotted Receiver with Cross Beam - Manual (Page 2)

TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336
www.tiedown.com (404) 344-0000 Fax (404) 349-0401
070814,A1293
Slotted Receiver
with Cross Beam
GalvX #86901 / Galvanized #86919
7
8
8
1
5
6
6
Installation Instructions for
4 foot wide docks :
1. Determine location of receiver based on
accessories to be used with it.
2. Receiver must be located at a location allowing
the cross beam to span the underside of the
dock and meet up with the Cross Beam
Mounting Plate on the opposite side
3. On the slotted receiver side of the dock drill
(2) 1/8" pilot holes in the bottom flange of the
side panel at 6.5" on center. Enlarge holes
using 1/2" drill bit. See exhibit 1.
4. Mount the slotted receiver in the holes using
2 of the 1/2" x 1" bolts (#9), 1/2" flat washers
(#10) and 1/2" nyloc hex nuts (11).
See exhibit 2
5. On the dock side opposite the receiver drill
(2) - 1/8" pilot holes in the bottom flange of the
side panel at 2" on center. Enlarge holes using
1/2" drill bit. See exhibit 3
6. Mount the cross beam mounting plate in the
holes using 2 of the 1/2" x 1" bolts, 1/2" flat
washers and 1/2" nyloc hex nuts. See exhibit 4
7. With the help of an assistant attach the cross
beam (6) to the receiver (5) and cross beam
mounting plate (1) using 2 each of the 3/8"
16x1" bolts (8) and flat washers (7) on each
side. See exhibits 2 & 4.
8. For Dock Side Accessories requiring two
receivers, the bolts securing the receiver to the
bottom flange of the side panel may need to be
loosened to allow proper alignment and
insertion of accessory support tubes.
6.5”
Exhibit 1
1/8” pilot hole
enlarged to 1/2”
9
Instruction Sheet #08179
7
11
11
10
10
9
2.0”
Exhibit 3
Exhibit 4
Exhibit 2
1/8” pilot hole
enlarged to 1/2”