Tie Down Cross Beam Extension - Manual

TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336
www.tiedown.com (404) 344-0000 Fax (404) 349-0401
011713,A1294
Cross Beam 28” Extension
GalvX #86916 / Galvanized #86934
MAKE YOUR DOCK A DESTINATION
Instruction Sheet #08180
Warning
Caution should be used when operating electrical
tools near water. Failure to use caution can result
in injury or death.
This Cross Beam 28” Extension is for extending standard 4 ft. cross beams to 6 ft. docks.
It is used with the Clamp Receiver with 4 ft. cross Beam part numbers 86918/86900
or Slotted Receiver with 4 ft. Cross Beam part numbers 86919/86901.
GalvX Dual Coat Finish - #86916 Parts List
# Part # Qty Description
1 86916 1 28" Cross Beam Extension
2 10598 2 3/8" x 1" Bolt, Zinc
Hot Dipped Galvanized Finish - #86934 Parts List
# Part # Qty Description
1 86934 1 28" Cross Beam Extension
2 10598 2 3/8" x 1" Bolt, Zinc
Top View
2
1
Tools Required:
9/16” Wrench or Socket and
assistance will be needed
to secure cross beam.