Tie Down ABS Stabilizer Plate - Manual

0
51
6
0
2,
31
5
ABS Stabilizer Plate Installation Instructions
Part #59293
1. Determine correct anchor to be used with the home installation and use the manufacturer instruction for
installation, following all safety precautions.
2. Using an electric drive machine, install anchor to a depth of approximately 28 inches at a slight
back angle.
3. Dig out an 8" wide area so that the ABS stabilizer will be placed on undisturbed soil at a 10 to 15 degree
angle toward the home. The bottom center of the plate should be touching the anchor rod.
4. Complete the installation of the ground anchor until the bottom of the anchor head is flush
with the ground.
5. Attach proper strap and tension strap until anchor head is flush against the ABS plate and strap is tight.
At this point, soil should be tamped into the vacant area behind the anchor rod, tamping approximately 6"
and repeating until the vacant area is flush with the surface of the surrounding ground.
1. 2.
4.
3.
Place ABS
Plate Here
Tamp Soil
In 6" increments