Tii 506F - Manual (Page 2)

3. Wrap the excess drop cable/fiber cable slack
in the clockwise direction and place it into the
base enclosure and under the slack retention
fingers.
4. Use a tie-wrap to hold any spliced connections
and cables to the strain relief pads.
5. Punch a hole through the right grommet and
guide the cable through the exit grommet.
6. Close and secure the cover. Tighten the
security hex screw until it is snug. Be sure not
to over tighten the screw.
Figure 3
Tie-Wrap
Strain
Relief Pad
Base
Slack
Retention
Fingers
Cable Slack
Entry
Grommet Exit
Grommet