Tii 506F-02-01-04 - Manual (Page 2)

Figure 2
Wiring
1. Punch a hole through the left grommet and
guide the Fiber Drop Cable through the entry
grommet.
2. Insert the SC connector from the pre-wired
fiber cable into the left side of the provided SC
Adapter.
3. Insert the SC Connector from the Customer
Out Fiber Cable to the right side of the SC
Adapter.
4. Punch a hole through the right grommet and
guide the Customer Fiber Cables through the
Customer Exit Grommet
5. Wrap the excess Fiber Cable slack in the
clockwise direction and place it into the base
enclosure and under the slack retention
fingers.
6. Use a tie-wrap to hold any spliced connections
and cables to the strain relief pads.
7. Close and secure the cover. Tighten the
security hex screw until it is snug. Be sure not
to over tighten the screw.
Figure 3
Internal Mounting
Holes
Entry
Grommet Exit
Grommet
External Mounting Ears
Customer Out
Fiber Cable with
SC Connector
SC Adapters
Provided Base
Cable Slack
Strain Relief
Pad with
Tie-Wrap
Slack
Retention
Fingers
Fiber Cable with
six Connector
Pigtail