Tii 8925 Series - Manual (Page 3)

11 plug in the jack at the location you will be
wiring.
8.2
Wiring the IDC terminals:
a) place IDC rockers in up position
(Figure 5);
b)
match wires, color-to-color (example:
red wire (ring) to red rocker; green wire (tip) to
green rocker);
c)
fully insert wire into the proper hole of
the IDC rocker;
d)
close rocker to full down position to ter-
minate pair (Figure 6).
8.3
Route subscriber wires through the wire
rungs attached to the subscriber bridge you will
be using (Figure 6).
8.4
Use approved practices to test the line.
FIGURE 5
IDC ROCKER IN
UP POSITION
WIRE RUNGS
IDC ROCKER IN
DOWN/TERMINATED
POSITION
FIGURE 6