Tii 761S-4M - Manual (Page 2)

Figure 2
8. Connect the existing phone and Media
Terminal Adapter (MTA) into their respective
RJ-11 receptacle
’s on the front face plate (See
Figure 3).
Figure 3
Existing Construction Installation
1. Cut drywall 2” W x 3.5” L in the location where
the 761-4 is going to be mounted. Prior to
cutting hole confirm that there are no
obstructions behind wall.
2. After drywall has been cut, install the metal
cut-in ring wall mounting plate. Bend the two
mounting tabs behind the drywall and secure
the mounting plate with the supplied drywall
screws (See Figure 4). Align the mounting tab
slots while tightening the screws.
Figure 4
3. Dress the wires properly inside the wall
mounting plate and secure the 761-4 to the
wall mounting plate using the supplied #6 oval
head screw’s (See Figure 5).
Figure 5
Removal & Installation of IDC
Rocker Assemblies
1. The IDC Rocker Assemblies are removable.
This will provide slack so the installer can
attach the wires from the electrical box to the
IDC’s if the wires are too short.
2. To remove, push in the clip located on the IDC
Rocker Assembly. Lift up and slide the out the
assembly from the 761 wall plate. (See Figure
6).
3. Attach the wires from the electrical box to the
IDC Rockers as per the installation notes.
4. To install, slide in the IDC Rocker Assembly
(wire side first) into the slots on the 761 wall
plate. (Be sure not to pinch the wires when
installing). Then push down on the clip side of
the assembly and snap it into the slot on the
761 wall plate. (See Figure 6).
Figure 6
Existing Junction Box
#6 Oval Head Machine Screws
#6 Drywall Screws
Wall Mounting Plate
#6 Oval Head Machine Screws
761 Plate
IDC Rocker Assembly
IDC Rocker
Assembly Clip
Push in to Remove
Push Down for
Installation