Specifications – Toa DA-250DH CE-AU User Manual
Page 14
14
220 – 240 V AC, 50/60 Hz
Class D
120 W (based on EN standards)
620 W (rated output 4 Ω x 2)
400 W (rated output 8 Ω x 2)
2 circuits, +4 dB* (1.23 V, input level control in maximum position),
10 kΩ, electronically-balanced, removable terminal block (3 pins),
XLR-3-31 type connector
CH 1 mode ON/OFF switch (ON: PARALLEL, OFF: STEREO)
2 channels:
250 W x 2 (4 Ω), 170 W x 2 (8 Ω)
1 channel (BRIDGE): 500 W (8 Ω)
M4 screw terminal, distance between barriers: 8.8 mm
20 – 20,000 Hz (±1 dB)
0.1% (1 kHz), 0.3% (20 – 20,000 Hz)
Protection against excessive current flow due to overload,
short circuit, unusual DC voltage output,
temperature rise at power amp. heat sink (over 100°C),
temperature rise inside the unit (over 80°C)
100 dB (A-weighted)
70 dB (A-weighted)
Power (blue) x 1, Input (green) x 2, Output (yellow) x 2, Peak (red) x 2,
Protect (red) x 2
Forced air cooling
–10°C to +40°C
Under 90%RH (no condensation)
Panel: Aluminum, black, alumite
Case: Plated steel sheet
482. (w) x 44 (h) x 401.8 (d) mm
5.3 kg
Power Source
Amplification system
Power Consumption
Input
Rated Output
Frequency Response
Total Harmonic Distortion
Protection Circuit
S/N Ratio
Crosstalk
LED Indicator
Cooling
Operating Temperature
Operating Humidity
Finish
Dimensions
Weight
14. SPECIFICATIONS
* 0 dB = 0.775 V
Note: The design and specifications are subject to change without notice for improvement.
Power cord (2 m) ................................................................. 1
Removable terminal plug (3 pins) ........................................ 2
Rack mounting screw (with plain washer) 5 x 12 ................ 4
Tamper-proof cap ................................................................ 2
• Accessories
14.1. DA-250D CE301, DA-250D CE-GB, DA-250D CE-AU