Toa ER-1206W - Manual (Page 3)

5. REPLACING THE BATTERIES
Step 3. After confirming the correct battery polarity,
close the battery case cover.
Ensure that the cover is securely locked in
place with the lock knob.
Step 2. Open the battery case cover, then insert AA
batteries.
To open the cover, unlock the battery case's
lock knob.
Four batteries are required for the ER-1203,
and six batteries for the ER-1206 series.
Step 1. Open the battery cover to remove the
battery case from the handle.
To release the battery cover lock, press the
lock tab in the direction indicated by the
arrow.
Note
If the megaphone is at all wet, be sure to dry it
thoroughly before opening the battery cover to
replace the batteries.
5.1. Using the battery spacer (ER-1206 series only)
The ER-1206 series can operate on four AA
batteries instead of 6 batteries with the additional
use of the supplied battery spacer.
Insert the battery spacer into the battery chamber
inside the case as shown below, then insert the four
batteries into the remaining two chambers according
to the battery polarity diagram attached to the case.
Step 4. Replace the battery case in the handle and
close the battery cover.
Take care about the correct orientation of
the battery case. To close the battery cover,
push the battery cover and slide the lock tab
in the direction of the arrow.
Note: Battery life when operated on 4 batteries is
shorter than when operated on 6 batteries.
The volume when operated on 4 batteries is
also lower than when operated on 6 batteries.
Therefore, adjust the volume to an appropriate
output with the volume control.
Battery spacer (supplied)
Cover
Polarity diagram
Battery case
Insert the battery case
with this slot faced inside.
Note
Be sure to insert the
battery spacer into this
designated position.
Handle
Battery case
Batter cover
Lock tab
Battery cover
Push
Remove
Open
Unlock
Battery case
Lock knob
AA battery
Cover
ER-1206 series only
2
1
Battery case
Cover
Lock knob
Polarity diagram
1
2
Handle
Battery case
Battery cover
Lock tab
Push the battery case
and slide the lock tab.
CAUTION
When changing 4-battery operation to 6-battery
operation, use all new batteries.
Using both new and old batteries together may
cause leakage or explosion of the battery,
resulting in a fire or personal injury.
Battery orientation is not the same for
all batteries.
Insert the batteries as shown below
noting correct polarity (positive and
negative orientation).