Toa HY-TM7W-WP - Manual (Page 3)

Step 2. Mount the speaker system to this bracket.
Mount the speaker system vertically, as shown in the figure.
Fix the speaker to the mounting bracket at all 3 indicated places.
2-1. Fix this bracket to both ends of the side angle plate of the speaker front.
Use the supplied bolts (with spring and plain washers) and spacers.
2-2. Fix this bracket to the speaker’s rear bracket.
Fix to the rear bracket’s endmost hole.
Use the supplied bolt (with spring and plain washers), J-spacer, and flange nut.
For details, refer to the procedures (1) to (3) as shown below.
• Use safety wires when installing speakers. If not used, personal
injury could result if a speaker should accidentally fall.
• Owing to the speaker's size and weight, be sure that at least two
persons are available to install the unit.
Failure to do so could result in personal injury.
• Tighten the bolts securely, as instructed below. Failure to follow
instructions precisely could result in a falling speaker and potential
personal injury.
· Ensure that all bolts are securely inserted as far as their threads go,
then securely fasten each bolt with a nut.
· Tighten all the bolts with the designated tightening torque. For
tightening, use a Phillips screwdriver, or open- or box-end wrench.
WARNING
This bracket
HX-7B-WP or HX-7W-WP
J-spacer
(accessory)
Rear bracket
(1) Lightly secure.
(3) Tighten firmly.
(2) Insert.
Flange nut
for M6 (accessory)
Hex head
bolt M6x30
(accessory)
Tightening
torque: 5 N·m
Spacer ø9.2 (0.36")
(accessory)
Hex head bolt
M6x12(accessory)
Side angle plate
Protection cover
Note
Remove the
protection covers
from the side
angle plates
before joining.
Tightening torque:
5 N·m
2
-1
Note
Similarly, fix this bracket to the end of the
side angle plate on the opposite side.
2
-2
This bracket
HX-7B-WP or HX-7W-WP
[Completed installation]
Step 3. Attach safety wires for protection against falls.
Regarding the attaching method of safety wires,
refer to the operating instructions supplied with
HX-7 Series speaker system.
Note
After tightening the bolt, ensure that
the J-spacer is firmly fixed.