Toa SR-M05R - Manual (Page 3)

7. FLOOR MONITOR SPEAKER INSTALLATION
The SR-M05L and SR-M05R are designed for installation on
the flat floor surface.
The parameters set on the DP-0206 Digital Processor permit
the speaker systems to reproduce the best quality of sound
under this installation condition. If installed above the floor, the
speaker systems cannot provide the intended sound quality.
6. CONNECTIONS
6.1. Basic Connection Diagram
6.2. Usable Power Amplifiers
As a principle, the output power of the power amplifier needs to be over 300 W (per channel and 8 Ω load).
If the amplifier rating is below 300 W, then the speaker cannot be operated to the fullest of its capability.
6.3. Parallel Operation of Two Speaker Systems
Cascade connection is possible for parallel operation of two speaker systems as shown in the figure below.
In this case, the power amplifier output must be over 450 W (per channel and 4 Ω load).
Parallel operation of two SR-F05s Parallel operation of SR-M05L and SR-M05R
DP-0206
DP-0206
DP-0206
INPUT
INPUT
INPUT
MAIN OUT
MAIN OUT
MAIN OUT
BASS OUT
SR-M05L/R
SR-F05
SR-F05
Power Amp.
Power Amp.
Power Amp.
Subwoofer
Digital Processor
Digital Processor
Digital Processor