Clearaudio Version-1.4_12_03_08_E - Manual (Page 7)

Ovation
User manual
Page 7  clearaudio electronic GmbH 2013
2.3
Now you can set the bearing upper part carefully onto the bearing.
To avoid damages make sure you slide the bearing upper part slowly and carefully on the polished
ceramic shaft.
2.4
Now you can set the sub-platter carefully onto the bearing.
First remove the security mat on the backside of the sub-platter
(security tape for OSC - graduated collar (Optical Speed Control)).
To avoid any damage, make sure you slide the sub-platter slowly and carefully onto the bearing.
After that, take the included belt and place it around the motor and the sub-platter. At this point the
sub-platter will be higher than the pulley. This is normal, as the CMB requires the weight of the
platter to fully engage it.
Pic. 4: Fitting the bearing upper part
Pic. 5: Setting the sub-platter Pic. 5.1: Moving the belt