Top Flite TOPA0704 - Manual (Page 13)

13
❏ ❏
3. On the top center rear of the wing is a hole with
a string taped. The opposite end of the string is taped
to the root rib of the wing. Tie two 24" [610mm] servo
extensions to the string and pull them through the wing.
Do this for both the left and right side of the wing.
❏ ❏
4. Tape the leads to the wing to prevent them from
dropping back into the wing.
❏ ❏
5. Glue a nylon pin into the forward hole in the root
rib of the wing center section. The pin should extend
approximately 1/2" [13 mm] from the rib. Do this on both
sides of the wing center section.
❏ ❏
6. Locate one of the carbon fi ber tubes with a
nylon insert and a pre-drilled hole in one end. The
hole is pre-tapped. Insert and then remove a 4-40

1"
[ 25 mm] socket head cap screw into the hole to check
that the tapped hole and bolt fi t well.