Traveler Guitar Ultra-Light - Manual (Page 5)

STRINGING AND TUNING
INSTALLING STRINGS:
The Ultra-Light uses standard ball-end strings. (Factory installed D’Addario EJ15.) No special tools are required for
string changes.
The tuners on your Traveler Guitar operate just like the tuners on a standard guitar. We recommend changing the
strings three at a time—but be careful not to remove all the strings at once, since some of the components are held
in place by string tension. First remove the old E, A, and D strings, and then install three new strings in their
places. Repeat this process on the G, B, and high E strings.
To change, thread the string through its hole in the endcap and wrap the string around the roller and through the
corresponding tuner hole. Leave approximately 2 ½ inches of slack in the string to allow 3 to 4 wraps on the
tuner. Bend the string to anchor it in place in order to hold the string after it is fed through the tuner. Over- or
under-wrapping the string around the tuner may cause tuning problems.
For further assistance, watch our restringing videos here and here.