Traxxas 56036 - Manual (Page 25)

E-REVO • 25
BASIC TUNING ADJUSTMENTS
DUAL SERVO STEERING SYSTEM
E-Revo uses dual-servo steering and a single heavy-duty servo saver for
powerful, responsive steering. To prevent unnecessary receiver battery
drain it is important to make sure that the servos are “at rest” when
the steering is at neutral. If one servo is out of adjustment, then both
servos will work against each other, fighting to find center.
Adjusting The Steering System
1. Remove the servo horns and steering links from the servos.
Disconnect the steering links from the servo saver.
2. Adjust both the steering links
to be the exact same length
(31.7mm - use “Steering
Servo Horn Link Length
Template” to set length).
3. Switch on the power to the
receiver and the transmitter.
4. Adjust the steering trim on
the transmitter to the neutral “0” position.
5. Connect one end of a steering link to the steering
servo saver arm and the other end to the servo horn.
6. Position the steering servo saver arm
perpendicular to the centerline of the vehicle.
7. While holding the steering servo
saver arm in the position mentioned
in step 6, install the servo horn onto
the servo such that the steering
link is parallel with the centerline of
the vehicle. This will automatically
set the servo horn at the 7-degree
offset shown in
the illustration.
8. Install the second servo horn on
the other side following the same
procedure.
If necessary, fine-tune the length of the second steering link to
eliminate any load on the steering system in the neutral position.
If you are using aftermarket servos, it is important to use servo horns
designed for E-Revo. Optional steering servo horns are sold separately
for use with non-Traxxas servos.
Servo Saver Tuning
An optional stiffer spring is available for the servo saver when using
servos with metal gear sets (see parts list for details). Do not use this
spring with standard Traxxas high-torque servos.
Maximum Travel Steering (optional)
The stock E-Revo steering system provides
a good balance between steering sensitivity
and turning radius. E-Revo includes an
optional maximum travel steering stop
which can be installed for maximum steering
throw, which may be desired in racing
applications. This provides sharper turning
at low speeds, but also makes the steering more
sensitive at high speeds.
To increase the steering
throw, replace the stock
steering stop with the
included maximum travel
steering stop on the model.
This part has modified
steering stops to allow
increased travel. Once
installed, reposition the
steering links to the outer
holes on both steering servo
horns. Refer to the exploded
views included with the
model to assist installation.
Steering Link Length Template
31.7mm
Stock Steering System
Maximum Travel
Steering Stop
Maximum Travel System Installed
If you have questions or need technical assistance, call Traxxas at
1-888-TRAXXAS
(1-888-872-9927) (U.S. residents only)