Traxxas 3351 Velineon 3500 - Manual (Page 14)

14 • VELINEON POWER SYSTEM
Antenna
Motor Wiring diagram
Velineon System Installation
10. Place waterproof receiver box top onto waterproof receiver box bottom and install
and tighten the two 3x10mm cap screws securely.
11. Inspect the waterproof box cover to make sure that the O-ring seal is not visible.
12. Arrange the wires neatly using the wire guides on the waterproof receiver box top (J).
Excess ESC and servo wiring should be bundled inside the waterproof receiver box.
Pull out all available antenna wiring from the waterproof receiver box.
13. Apply a small bead of silicone grease (Part # 1647) to the foam
on the waterproof receiver box wire clamp (K).
14. Install the waterproof receiver box wire clamp and tighten the
two 2.5x10mm cap screws securely (L).
15. See page 18 for VXL-3s setup and operation.
K L
J
KC1211_R01 Velineon_System_Man.indd 14 12/1/09 6:01:55 PM