Triner Scale RAVAS-310 - Manual (Page 13)

13
 Press the  PT key until the display changes and the last digit is blinking (approx 3
seconds).
 The display shows the current tare value.
 The right digit is blinking.
 Press the  key to go up a value or press the  key to go down a value until the
required value is reached for that place.
 Press

to change to the next digit.
 Repeat this procedure until the required tare value is displayed.
 Press ENTER (

) to activate the tare weight.
 The tare weight is activated.

The “NET” pointer lights up.
 When the system is loaded, the net value appears in the display
 When the system is unloaded, the read-out displays the negative value of the
given tare.
 The entered value remains active until a new tare weight is entered (display
shows the new net weight).
 Press the T key to return to gross weighing mode.
PIECE COUNT: SAMPLING
If an unknown piece weight is to be determined you may do this by sampling a
certain number of pieces. The number of pieces taken from or placed on the scale
determines the accuracy of the sampling. The total weight of the pieces taken from or
placed on the scale for the sampling should be no less than 9-10 lb. The greater the
weight difference, the greater accuracy. The standard sampling amount is 10 pieces,
but this number can be increased up to 95 pieces. (wordy)
 Press the key.
 The
display shows “add10”. The “lb” pointer changes to “pcs”.
 Take or place 10 pieces from/on the scale and press the ENTER (

) key.
 The sampling is done and the display will show the total number of pieces on
the scale.
Or
 Press the

key or the

key to change the number of pieces to add.

The display will show the new value to add. (for example “add50”)
 Take or place 50 pieces from/on the scale and press the ENTER (

) key.
 The sampling is done and the display will show the total number of pieces on
the scale.
To return to the normal weighing mode press the key for 3 seconds.
PIECE COUNT: ENTER A PIECE WEIGHT
 Press the key for 3 seconds.
 The last used piece weight will be displayed with the right digit flashing.
 To accept the old value press ENTER (

).
 The display shows the number of pieces currently on the scale.