Power up—aircraft stationary, Mode and data display, See initializing the autopilot page 4 – TruTrak Digiflight Operation Manual User Manual

Page 4

Advertising
background image

3

POWER UP—AIRCRAFT STATIONARY

SEE INITIALIZING THE AUTOPILOT PAGE 4

Mode and Data
Display

This display normally

shows operating modes and
associated numerical data. It is
also used to display setup mode
screens and the setting of
associated numerical data.
When displaying operating
modes, the left side shows
lateral data and the right side
shows vertical data. (See figure
below.) The upper left display
labeled

TRK

shows the

electronic DG slaved to GPS
track. When the GPS track is
not available

TRK

will be

replaced by

MAG

, which means

the autopilot now uses an
internal source of magnetic
information for direction. The
lower left display labeled

SEL

shows the selected direction of
flight. In the Digiflight 200 and
200 VS, the upper right shows
whether or not the unit is in the
altitude hold mode. The lower
right display shows selected
vertical speed or whether the
autopilot is on of off.

With the Digiflight 200VS,

the vertical space between
theleft and right hand display

area is used to show pitch trim.
This display consists of three
horizontal bars spaced
vertically as the rungs on a
ladder, and are made to move
up or down when the aircraft is
in need of being trimmed.

In the upper left where

direction is shown, a flashing
indicator is present between

TRK

or

MAG

and the numerals

that follow. When there is GPS
serial data present but no
position fix, this will be a
flashing period. Once GPS
position data becomes valid this
will be a flashing asterisk. If
GPS flight plan information is
being received over the serial
channel or if the

GPS-S-

option

has been added and GPS
steering information is being
received, a flashing plus sign
will indicate the presence of a
useable steering (

GPS-S-

mode)

or waypoint to waypoint (

GPS

NAV

mode) signal.

A cursor in the form of an

underline is shown beneath the

SEL

numerals. This is used to

indicate that an underlined
number will be set by rotation
of the encoder knob.

TRIM INDICATOR

TRK*135 ALT HOLD

SEL 135

SVS 0

DG SLAVED
TO TRACK

SELECTED
DIRECTION

SELECTED

VERTICAL SPEED

Advertising