Tuffy Security 063 - Manual

Page 1 of 3 - 1/28/2008 – Rev122006
INSTALLATION INSTRUCTIONS
Rear Cargo Drawer – Part #058 and #063
Please read and fill out the enclosed warranty registration card to activate your warranty.
Shipping Package
• (4) 7/16 x 1 ¼ Bolts
• (4) 7/16 Nylock Nuts
• (4) 7/16 Washers
• (2) 8MM Metric Bolts
• (2) 5/16 Washers
• (2) ¼” Serrated flange nuts
• (4) ½” Hole Plugs
• (1)
Drawer Handle
NOTICE!
DRAWER WILL HAVE TO BE REMOVED FOR INSTALATION
INSTRUCTIONS FOR REMOVING DRAWER
Before attempting to install your new Tuffy Drawer, it is necessary to remove the drawer from the
body. To do this, pull the drawer out as far as it can go then locate the small black plastic stops
visible on the ball bearing drawer slides. One of the black stops will need to be deactivated by
pressing down and the other one pulled up. Be careful not to break plastic stops. While deactivating
the stops pull the drawer out and the slides will separate. When you are finished installing your
drawer, line up the slides and push the drawer back in.
WARNING: If you are bolting your drawer through the side holes, be sure not to overtighten the bolts
which can cause the top of the enclosure to “flex” downward. It may be necessary to install a spacer
between the side of the drawer and the vehicle sidewall to prevent this bowing.
Mounting Directions
• Insert the studs on the drawer handle
into the corresponding holes in the
drawer. Secure handle with the ¼” nuts.
• If you are not going to use the side
mounting holes, use the hole plugs
provided.
• If you have any Rear Cargo Drawer
accessories (Divider or Riser Kits), refer
to their individual instructions for
installation
•
If you do not have any Rear Cargo
Drawer accessories and would like to get
some, call your nearest Tuffy Security
Products dealer or call Tuffy direct. The
divider kit allows you to neatly
compartmentalize while the riser kit
allows you to store items such as the soft
doors under the drawer.