Step 4 – filter rails (continued), Step 5 – filters, Step 6 – hood rails – Twin City Modular Gravity Hood - MGI with Filters - IM-4720FSL User Manual
Page 3
3
Twin City IM-4720FSL
Stiffener Angle
Hex Nut, Flanged
Screw, Flanged Head
Step 4 – Filter Rails (Continued)
Fasteners (Kit #6B):
Attach
Stiffener Angle with cap screws and
nuts, hand tighten. For base widths 42" and
larger, assemble
Filter Channel, Type -C- by
sliding channel into
Filter Stop Plate channel and
then bolting to
Stiffener Angle. See Detail A.
Figure 5.
Filter Rail, Type -C-
DETAIL A
THROAT WIDTH 42" & LARGER
Filter Stop Plate
Stiffener Angle
Step 5 – Filters
Slide filters into assembly and tighten all fasteners.
Figure 6.
Step 6 – Hood Rails
Fasteners (Kit #3) –
Note: There may be extra fasteners.
For hoods 120" and longer, see Detail A in Figure 7 and bolt together
Hood Rail Sections with 5/16" hardware.
Install two
Hood Rail Assemblies to the Hood Mount Bars using cap screws and nuts. Do not fully tighten fasteners.
They will be tightened in Step 9.
A
Base Assembly
Hood Rail Assembly
Nut, Flanged Head
Screw, Flanged Head
DETAIL A
FOR HOODS 120" AND LONGER
Screw, Flanged Head
Hex Nut, Flanged Head
Figure 7.