Outside patio or lanai installation – Twin Eagles TEVH60-B User Manual

Page 6

Advertising
background image

Page 6 of 8 11503.00 Rev C

Outside Patio or Lanai Installation

Construction methods and installation shall comply with all local building codes. Internal
ducting shall be sealed using outdoor rated metal duct tape.

The Twin Eagles hood with stainless steel canopy is approved for installation in an outside patio or lanai area if
the area is covered with a protective roof over the hood (wall style hoods are to be also mounted to a solid
protective rear wall)
and installed with a GFCI protected branch circuit. Roof or Wall Caps are to be sealed to
prevent moisture migration to structure interior; use an outdoor rated sealant suitable for adhesion to the
installation materials. See Fig-8 for rear exhaust installation and Fig-9 for top exhaust installation.

A

A

B

Wall Cap

Rear

Exhaust

Fig - 8

Front View

A = 42" Minimum

B = 30" Minimum

Side View

See Fig – 10 for structure with elevated roof/ceiling.

The Roof shall cover the top of the hood and extend a minimum of 42” from each side of the hood and 30”
minimum from the outer most edges of the hood front.

Since, outdoor areas are subject to strong cross drafts it is recommended that the hood extend at least 3 – inches,
and preferably 6 – inches, over either side of the cooking area to maximize the cooking discharge capture area.
Cross drafts will affect the efficiency of the ventilation system and cooking discharge can escape capture by the
hood/ventilation system. Be sure to plan for adequate ventilator (blower) capacity to minimize cross drafts
influencing the removal of cooking discharges.

The installation instruction that
accompanies the hood shall be followed
to ensure all safety Instructions and
guidelines are adhered to. NOTE: Hood
is recommended for use over domestic
gas or electric appliances. Not
recommended for use over solid fuel
fired appliances. See Fig-10 for soffit
construction

B = 30" Minimum

A = 42" Minimum

Front View

A

Side View

Exhaust

Top

B

Soffit

Roof Cap

Fig - 9

A

12"

See Fig – 10 for structure with elevated roof/ceiling.

Advertising
This manual is related to the following products: