USL DAX-602 User Manual

Page 9

Advertising
background image

DAX-602/802

INSTRUCTION MANUAL

Ultra Stereo Labs, Inc.

- 16 -

Analog Output Connector: (25 pin D sub Male) (Balanced or Unbalanced Line)
Note: In Unbalanced mode the negative signal MUST be connected to ground.
To minimize ground loop hum, the negative side of the output should be connected
to ground at the signal desination instead of at the DAX. Twisted pair shielded
cable should be used.

HI/VN-N Output Terminals: Hearing impaired audio and visually impaired narra-
tion audio are available on a terminal strip on the rear panel of the DAX. These
outputs can drive balanced or unbalanced loads. When driving unbalanced loads,
connect the negative output of the DAX to ground at the destination end of the
cable to minimize ground loop hum. Use twisted pair shielded cable to carry the
HI/VI-N audio to the transmission equipment (such as the USL IRC-28(C)).

DAX-602/802

INSTRUCTION MANUAL

Ultra Stereo Labs, Inc.

- 9 -

Equipment Class
Type A: Equipment that is intended for connection to the building power supply wir-
ing via nonindustrial plugs and sockets or via appliance couplers, or both.

Disposal and Recycling
Wheelie-Bin Symbol

The Wheelie-Bin symbol is attached to this product in compliance with
the EU Directive 2002/96/EC on Waste Electrical and Electronic Equip-
ment (WEEE). Its purpose is to deter the improper disposal of this prod-
uct and to promote reuse and recycling.

Proper Disposal
In conformance with the Directive, at end of life this product should be either sent
to an appropriate recycling facility for disassembly and recycling or returned to the
VXSSOLHU8QGHUQRFLUFXPVWDQFHVVKRXOGWKLVSURGXFWEHGHSRVLWHGLQDODQG¿OOIRU
disposal.

Hazards of Noncompliance
Electrical and electronic products may contain chemicals which can leach into
the groundwater and cause health concerns through contaminated drinking water.
Failure to dispose of this product in compliance with the WEEE Directive may re-
sult in penalties as determined by local ordinance.

Please contact your dealer or USL, Inc., with questions regarding the proper dis-
posal of this or any other USL product. USL, Inc. contact information: USL, Inc.,
181 Bonetti Drive, San Luis Obispo, CA 93401-7397, USA. Phone: +1 805 549
0161 Fax: +1 805 549 0163 www.uslinc.com

Advertising
This manual is related to the following products: