Water Factory Systems FM1500 Faucet - Manual (Page 6)

STEP 1: The mounting bracket may be installed
with the back of the bracket in the up or down position.
Screws may be used to attach the bracket to the
de sired surface or industrial double-sid ed tape can be
used to mount the bracket. Be sure that both the sur-
face of the bracket and the mounting surface are clean.
Be sure to allow at least 2" (5 cm) of clear ance below
the unit. (Figure 1, Page 8)
Important: If inverting the bracket, note that the in let
port is marked “3”. Outlet port is marked “1”. All
other markings on the filter head are to be ignored.
STEP 2: The filter must be installed with the inlet
and outlet ports as labeled. Make sure not to reverse
the con nec tions. The shut-off valve is located in the
inlet fitting.
STEP 3: Attach the head to the bracket with the screws
provided. All four screws can be used, or two can be
used to mount the bracket to the de sired surface.
STEP 4: Install cartridge (see Page 7). Pressurize the
system and check for leaks. Flush 3 gallons through
system before use (approximately 6 min). Water may
run cloudy but will quickly clear.
Procedure For Installing FM DWS 1500 Water Appliance
Before starting, close shut-off valve on cold water line.
1 2
3 4
6