Winco 2-Wheel Dolly Kit Assembly Instructions - Manual (Page 3)

3 206-0 6204-005I
Thread bolt (ref. 7) onto tube clamp (ref. 5) convex side up as shown.
With a hammer gently tap tube clamp (ref. 5) into leg support and handle (ref. 3)
approximately /2 inch. Remove bolt (ref. 7).
Assembly bolt (ref. 7), bumper (ref. 9) and washer (ref. 4) according to the pic-
ture below. Tighten assembly onto leg support and handle (ref. 3).
Soak rubber grip (ref. 7) in soapy water prior to installation. Place rubber grip on
leg support and handle using a twisting motion.
Repeat for other leg support and handle assembly.
•
•
•
•
•
STEP 2
STEP 3
Remove the generator from the pallet and block generator up 8 to 0 inches to
gain access to the bottom of the cradle assembly. A lifting jack or hoist may also
be used if available.
•