Zapco ST-series D - Manual (Page 8)

INPUT
CH1
CH2
CH3
CH4
250Hz 50Hz
FREQ
- - + +
CH1 CH2
HI-INPUT
MAX MIN
GAIN
12dB 0dB
BASS
LPF HPF FULL
250Hz 50Hz MAX MIN 12dB 0dB
ST-4D
- - + + CH3 CH4
FREQ GAIN BASS HI-INPUT
CHANNEL 3/4
CHANNEL 1/2
250Hz 50Hz
FREQ
- - + +
CH1 CH2
HI-INPUT
MAX MIN
GAIN
12dB 0dB
BASS
INPUT
LPF HPF
CH1
CH2
CH1
CH2
FULL
OUTPUT
ST-2D
Connect your source unit to the amplifier using the "INPUT" RCA connectors. The "OUTPUT" connector
can be used to pass the input signal to another amplier. For Initial Setup: Always set bass boost to 0dB,
and set the amplifier gain to minimum (8V sensitivity). Remember: amp gain is not a volume control.
It is used only to match your amplifier input sensitivity to your source unit output.
to INPUT of
ADDITIONAL
AMPLIFIERS
RCA CONNECTION
ST-2D
HEAD UNIT
ST-4D
HEAD UNIT
-5-