Zapco Z-series B - Manual (Page 8)

Connect your source unit to the amplifier using the "INPUT" RCA connectors. The "OUTPUT" connector
can be used to pass the input signal to another amplier. For Initial Setup: Always set bass boost to 0dB,
and set the amplifier gain to minimum (8V sensitivity). Remember: amp gain is not a volume control.
It is used only to match your amplifier input sensitivity to your source unit output.
to INPUT of
ADDITIONAL
AMPLIFIERS
Wired Remote Control
(optional)
RCA CONNECTION
Z-150.2
HEAD UNIT
250Hz 12dB 30Hz 0dB
LPF BASS
CH1
CH2
CH1
CH2
PWR
PRT
HPF LPF
REMOTE
500Hz 50Hz
FULL
INPUT
0.2V 8V
GAIN
OUTPUT
HPF
Z-400.2
Wired Remote Control
(optional)
HEAD UNIT
to INPUT of ADDITIONAL
AMPLIFIERS
-7-