Philips FW890P37 - Manual (Page 15)

To start the demonstration mode
• Press and hold ■ (on the system only)
for five seconds when the system is in
standby mode.
-*■ The demonstration will begin.
Easy Set
EASY SET allows you to store all available
radio stations automatically.
1 Press and hold STANDBY ON (on the
system onlyjtoi five seconds, when
the system is in standby or
demonstration mode.
TriST SET" will be displayed,
and followed by "TUNER" and then
"HlJTO".
EASY SET will start searching for all
radio on FM band and then followed
by radio stations on AM band.
All available radio stations with
sufficient signal strength will be
stored. Up to 40 presets may be
stored.
Notes:
- EASY SET will start with the EM band, if
there are still presets available, the
system will continue to store the AM
band.
- When EASY SET is used, all previously
stored radio stations will be replaced.
- Tbe last preset radio station will appear
on tbe display when EASY SET is
completed.
Switching the system ON
• Press CD, TUNER, TAPE or AUX.
You can also switch on the system by
pressing any one of the CD DIRECT PLAY
buttons.
Switching the system to
standby mode
• Press STANDBY ON again or (¡) on the
remote control.
-* The system will switch to standby
mode.
-* About 5 seconds later, the system
will go into an energy saving mode
(< 2 watts). The low power
STANDBY ON LED will be lit.
Selecting the Source
• Press the respective source selection
button: CD, TUNER, TAPE or AUX
-* The display indicates the selected
source.
Note:
- Eor an external source, make sure you
have connected the audio left and right
OUT terminals of the external
equipment (TV, VCR, Laser Disc player,
DVD player or CD Recorder) to the AUX/
CDR IN terminals.
Selecting the Equalizer
Display
You can select the desired equalizer display
for the system. You must not press the DSC
button on the system before using the JOG.
• Rotate the JOG to select the desired
Equalizer Display, PEAK HOLD, MIDDLE
OUT, TOP DOWN, NORMAL, or NITE
MODE.
The selected display will be shown.
PEAK HOLD Display
IKHW
MIDDLE OUT Display
ipmw №0 «K-G
CUSSIC yocAi
TOP DOWN Display
jpjm IBHM IOC« 0 » cncs|[ nrrr
NORMAL Display
inm ^ ^ flit]
MTI| 1 I EMM lowiKMOMi) r;« awai Ljj.rrj)
«K« ^ ^ ^51
OPERATING THE SYSTEM
NITE MODE Display
ticwM f«'»T r—
\Z ‘."J'
nis<
yx
Note:
- In NITE MODE, all lights will be
switched offend the display brightness
will be dimmed.