Philips HP6576-60 - Manual (Page 6)

Overheat protection
Note:To ¿ivoid oveitieating of the epilator: do not
press the appliance too hard onto your skin.The
Epilator works best when you move it over vour
skin without exerting any pressure.
D
If the overheat protection is activated, the
appliance turns off automatically.
The speed setting indications and the charging
light blink red.
B Let the appliance cool down.
IThe lights stop blinking after 30 seconds.
H When the appliance has cooled down, you
can turn it on again.
If the lights start to blink red again, the
appliance has not yet cooled down completely.
Overload protection
If you press the epilating head too hard onto your
skin or when the rotating discs of the epilating
head get blocked, the appliance stops and the
speed setting indications start to blink red for 5
seconds.
Q Turn off appliance.
B
Check if the rotating discs of the epilating
head are blocked by turning the discs with
your thumb. Remove any blockage from the
rotating discs.
B Turn on the appliance again.
Travel lock
The Epilator has an integrated travel lock which
prevents the appliance from accidentally being
switched on during travel.
Q To activate the travel lock, press and hold
the ON/OFF button for 3 seconds until
the speed setting indications blink white 2
times (Fig. 7).
► The Epilator starts running and stops
immediately when the travel lock becomes
active.
B
To deactivate the travel lock, press and hold
the on/off button for 3 seconds until
the speed setting indications blink white 2
times (Fig. 8).
NOTE:The travel lock is deactivated automatically
when YOU connect the appliance to the outlet.