Philips AZ1010-17 - Manual (Page 3)

BASIC FUNCTIONS
©POWER:
CO, TAPE, SAND .. .selects the sound source
©DBS............................enhances the bass
©VOLUME.................... adjusts the volume level
©0................................3.5 mm headphone socket
(back of the setj
Note: Connecting the headphones will switch
off the speakers.
©CASSEHE RECORDER
PAUSE OD................ pauses recording or
playback
STOP OPEN □ A stops the tape and opens
the cassette compartment
SEARCH ....................rewinds the tape
SEARCH ....................fast forwards the tape
PLAY <......................starts playback
RECORD O................starts recording
RADIO
©TUNING...................... tunes to radio stations
©BAND: FM, AM ... selects the wave band
©CO PLAYER
A OPEN.................... opens the CO
compartment
□............................. stops CO play and erases
the program
>110........................ starts and pauses CD play
t>w.......................... skips and searches
forward
HM.......................... skips and searches
backward
CD MODE................. selects the different CD
playing modes and
programs tracks
® Display
PWVER SUPPLY
iBaUiriwiaiHianll
Open the battery compartment of the set and insert 6 batteries,
type R20, UM-1, or D-cells (preferably alkaline].
Remove batteries if they are dead or if the set is not going to be
used for a long time.
Batteries contain chemicaf substances, so thay should be
disposed of properiy.
V.:
|AC iMHOTf ropply
1 Check whether the voltage as shown on the type plate
corresponds to your local voltage. If it does not, consult your
dealer or service organization. The type plete is located on
die bottom of the set
2 If the set is equipped with a VOLTAGE selector ©, set this
selector to the local voltage
3 Connect the AC power cord to the AC MAINS socket and to the
wall socket. This switches on the AC power supply. The AC
power cord is inside the battery compartment
The battery supply will be switched off when the set is connected
to the AC power. To change to battery supply, disconnect the AC
power cord from the unit s AC MAINS socket.
To disconnect the set from the AC power completely, remove the
AC power cord from the wall socket.
The sefcomp/№S if» Part IS andwhh 2 t CPR 1040 . 10 . Operation is
subject to the following two conditions:
1 . This device thay not Pause harmfunrrtei^
2 . This dewtx must aet^ any interferm^ r&:eived. including interference that
may cause undesired operation.