Hyundai H-CMD4000 - Manual (Page 14)

14
General operation
Reset the unit
Operating the unit for the first time or after replacing the car battery, you must reset the unit.
Press
button on the panel to open the panel and press the RESET button to restore the unit to the original
factory settings.
Power button
Press PWR button to turn the unit on.
Press and hold it for 2 seconds to switch the unit off.
Note: After the unit is off, the volume level and radio current settings will be memorized, and when you turn the
unit on it will resume the stored status which you set.
Volume control
Rotate the VOL knob on the panel clockwise or press the VOL + on the RC to increase the volume level.
Rotate the VOL knob on the panel anticlockwise or press the VOL - on the RC to decrease the volume level.
Setting the sound characteristics
Press shortly and repeatedly the SEL button to select the audio setting:
BASS => TREBLE => BALANCE => FADER.
Rotate the VOL knob to adjust each setting. The display will show the
following:
Note:
If turning off the power all the settings of each mode will be saved.
If turning off the ACC power all the settings will become as they were set on the plant as current.