DeLonghi EC 140 Series - Manual (Page 3)

SHORT CORD INSTRUCTIONS
A short power cord is provided to reduce the risk resuiting from entangiementor
tripping
overaiongercord. Longerdetachabiepowersupplycordsareavaiiabieand
maybe used if careisexercisedin their use. If a longerdetachabiepower cord or
extensioncord is used (1) the marked electrical rating of the extension cord should
be at leastasgreatasthe electrical rating of the appliance,and (2)the Iongercord
should be arranged so that it will not drape overthe countertop or table top where it
can be pulled on by children or tripped over unintentionally. Theelectricalrating of
the applianceis listed on the bottom of the unit. If the applianceisof the grounded
type, the extensioncord should be a grounded type 3 wire cord. Thisappliancehas
a polarized plug. One blade is wider than the other. Toreducethe risk of electrical
shockthis plug will fit in a polarized plug only one way. If the plug doesnot fit,
contact a qualified electrician. Do not attempt to modify the plug in anyway.
BEFORE FIRST USE
Placethe box on a large, sturdy flat surface. Carefullyunpackyour espresscmaker
and remove all packaging material and literature. Removeanylabelsor stickers
from the machine. To remove any dust that may haveaccumulatedduring
packaging,you may wipe the unit with a clean,damp cloth. Dry thoroughly. Do not
immersethe espresso makerin water or other liquid. All accessories (filter holder,
drip tray, measuringspoon,filter) must be washedwith warm water and mild
detergent. Rinseand dry thoroughly. Do not use harsh or abrasivecleaners. (See
QeaningYour EspresscMaker section of this manual for detailed instructions.)
Keepall plasticbagsawayfrom children. NOTE: We recommend that prior to
brewing your first espressopperatethe espresscmakeronce or twice with water
only, without ground coffee. Thiswill remove any dust that may have settled inside
the espresscmaker; which mayaffect the flavorof the espresso.CAUTION: W^er
is HOT
1. Placethe espresscmakeron a flat, level surfaceaway from any edge.
Plug the unit into a 120V/ OOHzonly outlet.
2. Pressthe ON/OFFswitch and the delivery switch. TheON/OFRight will
illuminate and the pump will switch ON.
3. Wait until water beginsto flow from the boiler nozzle. Thenturn the water
deliveryswitch OFF. After about 2 minutes the OK indicator light will
illuminate indicating that the boiler hasreachedthe correct temperature.
4. Pressthe water deliveryswitch ONagainfor 10-15seconds,allowing
waterto flow from the boiler nozzle. Thenturn the water deliveryswitch
OFF
5. To ensureperfect pre-washing,repeat this procedureat leastfive or six
times. The machine is now ready for use.