Homelite LM-990932 - Manual

[KI(o)[!^[l[LDTr[l*
INSTRUCTIONS & R\RTS UST
42” FRONT BLADE
ASSEMBLY
Fasten the two supportami assemblies to the push frame with
a capscrew, lockwas her and hex nut {see fig. 1). Do not tighten
completely until after the combined assemblies are installed
on the tractor.
2. Attach the push frame to the rear holes of the front mounting
brackets on the tractor with a pin and spring clip on eachside.
Mount the support arm assemblies to each side of the tractor
frame (see illustration) with a pin and spring clip on each side.
Now tighten the nuts securing the support arm assemblies to
the push frame.
3. Slide the pivot rod through the push bar assembly and the push
frame and secure with a spring clip on each end.
4. Slide the front of the push bar assembly into the mounting
bracket on the back of the 42" blade. Secure with the king pin
and spring clip in the forward hole. Place the pivot pin the
rear hole.
5. Slide the guide tube and the set collar onto the unthreaded end
of the lift rod and tighten the set collar with the set screw.
Attach a hex nut and the yoke to the threaded end of the lift rod
and connect to the upright arm on the push bar assembly with
the yoke pin and a spring clip. For ease of attachment place
the lift lever in the down position. Push pin side of guide tube
through the hole in the lift lever and secure with a spring clip.
PART NO. 24715-4
Supersedes No, 24715