Putting in the coffee – DeLonghi DC76T User Manual

Page 9

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

NOTE: The amount of brewed coffee after the brewing process will

always be slightly less than the amount of water placed into the

coffee maker, since some water is absorbed by the coffee grounds

and filter. Add a little extra water at the beginning so that you have

the exact number of cups desired.

PUTTING IN THE COFFEE

• Swing the filter basket door outward to your left. Lift out removable filter

basket. Insert the permanent filter (a #4 cone-shaped paper filter can

alternatively be used.) Fill the filter with the required amount of coffee.

After brewing cycle, empty the grounds and hnse thoroughly with water.

• Place the desired amount of ground coffee into the filter. According to

coffee industry standards, use one standard coffee measure (2 level

tablespoons) of grounds for each six ounces of water. After using your

coffee maker several times, the amount of coffee may be adjusted to suit

your particular taste by decreasing or increasing the amount of coffee

used.

NOTE: Be sure to use coffee grounds prepared specifically for

automatic drip coffee makers.

• Return the filter basket with the filled filter to the door. Be sure the filter

basket is seated properly in the door. Swing the door closed and snap into

place.

CAUTION: Do not operate your coffee maker if the door does not close

completely. If the door does not close completely, check to see that the

filter basket is properly sealed, and snap door into place.

• Press the Power Select Button. Auto Start Light will go on. Press the

Power Button again, then the On Light will go on indicating that the coffee

maker has begun the brewing cycle. In a few minutes the coffee maker

will complete the brewing cycle and switch over to the warming mode

which will keep the coffee hot for two hours.

Advertising