Resetting the clock after a total memory loss – Emerson SMARTSET CKS3029C User Manual

Page 19

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

1.... I

RESETTING THE CLOCK AFTER A TOTAL MEMORY LOSS

If you do not change the built in lithium battery within a reasonable period of time

after you see the ‘flashing’ LOW ВАТТ, warning indicator, the lithium battery may

become exhausted and will no longer be able to supply back up power to the

SmartSet® internal computer. If the unit is disconnected from the AC outlet after

the battery is exhausted, or if a power interruption occurs, the SmartSet® memory

will be lost and the clock will need to be reset when the power Is restored. Be sure

to install a fresh lithium battery before you reset the clock, otherwise the clock will

need to be reset each time the power is interrupted.

If the lithium battery is exhausted and you experience an interruption in the

AC power supply, the clock will reset itself to its initial default setting when the

power is restored.

The initial default setting is “AM 12:00, Saturday, January 1®* (1 1), 2005”.

if you notice that the time on your SmartSet® clock,radio is completely incorrect,

and the day indicator is also wrong, press the MONTH/DATE button to see the

Date. If the Date display is showing “1 1" (January 1®‘), you probably experienced

a total memory loss.

To reset the clock after a total memory loss, proceed as follows:

1. ) Follow the instructions on page 16 and install a new CR2430 lithium battery in

the battery compartment.

2. ) Connect the radio to your AC outlet and let the clock set itself.

3. ) Depress the MONTH/DATE and TIME buttons together. The display will change

from ‘time’ to ‘year’.

While holding the MONTH/DATE and TIME buttons, press the UP button to

set the display to the correct year, then release the buttons.

4. ) Depress the MONTH/DATE button. The display will change from ‘time’ to

‘monih/date’ (mm/dd).

While holding the MONTH/DATE button, press the UP button to set the display

to the correct month and date. The Day indicator will change automatically as

you adjust the month/date settings. When the correct month and date appear

on the display release the buttons.

-Cf-

18

CKS3029C_080106.p65

1/8/2006, 9:25

Advertising