Homelite LM-16001-72 User Manual
Mfr'snal72, A(o)[iiiq[ml.dir[l’ assembly, Assembly instructions and parts list
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Mfr'sNal72
V_____________ ^____________ _
[>a(o)[iiiQ[ML.Dir[l’
Assembly
1. Install the lift shaft on the rear of the tractor with the
two set collars inside the brackets as shown. Secure
with the two setscrews provided (Figure 1).
2. Mount the upper arms of the frame assembly on the lift
shaft, then align the holes in the lower arms with the
holes in the tractor frame and secure with two pins and
two quick pins (Figure 1).
3. Mount the drive pulley on the tractor PTO shaft using a
key and secure with the setscrew provided (Figure 2).
540 Ш. FtiwerTake Off No.LM-16001-72
forT-I0,M2,T-15&T-16TrattOR
Assembly Instructions and Parts List’
4.
Install the belt stops as shown. Adjust the upper belt
stop for 1/8 inch clearance between the belt and the stop.
Adjust the lower one for 1/16 inch to 1/8 inch clearance
between the belt and the stop. The capscrew provided
for the upper belt stop replaces the original capscrew on
die tractor.
Lubrication
The 540 R. P. M. PTO unit has three standard size grease
fittings. One fitting on each bearing housing and one on the
frame assembly. They should be lubricated occasionally
with general automotive type grease. Be sure to wipe each
fitting clean before greasing to prevent grit and dirt from
being carried into bearings with the new grease.
Part No, 24755