Sears 315.220100 User Manual
Operator's manual, 10 in. stationary radial arm saw q
Advertising
Table of contents
Document Outline
- Operator's Manual
- WARRANTY
- INTRODUCTION
- TABLE OF CONTENTS
- TABLE OF CONTENTS
- MEANING
- IMPORTANT
- READ ALL INSTRUCTIONS
- ■ DO NOT USE IN DANGEROUS ENVIRONMENT.
- ■ KEEP CHILDREN AND VISITORS AWAY. All
- USE THE RIGHT TOOL FOR THE JOB. Do not
- REMOVE WRENCHES AND ADJUSTING KEYS.
- DO NOT FORCE THE TOOL. It will do the job
- BEFORE MOUNTING, DISCONNECTING OR REMOUNTING THE MOTOR; unplug the saw and
- GUARD AGAINST ELECTRICAL SHOCK by
- DO NOT OPERATE THIS TOOL WHILE UNDER THE INFLUENCE OF DRUGS, ALCOHOL, OR ANY MEDICATION.
- USE A SUPPORT FOR THE SIDES AND BACK
- CUT ONLY WOOD, PLASTIC OR WOOD-LIKE MATERIALS. Do not cut metal.
- DO NOT REMOVE THE SAW'S BLADE GUARD.
- KEEP HANDS AWAY FROM CUTTING AREA.
- DO NOT FEED THE MATERIAL TOO QUICKLY.
- BLADE COASTS AFTER BEING TURNED OFF.
- USE ONLY OUTDOOR EXTENSION CORDS.
- SAVE THESE INSTRUCTIONS
- ADDITIONAL SAFETY RULES FOR RADIAL SAWS
- ELECTRICAL
- ELECTRICAL
- PRODUCT SPECIFICATIONS
- GLOSSARY OF TERMS FOR WOODWORKING
- GLOSSARY OF TERMS FOR WOODWORKING
- UNPACKING
- ACCESSORIES
- LOOSE PARTS LIST
- [
- J
- LABELS
- AWARNING
- ADVERTENCIA
- DJUSTMENT
- DRAW A STRAIGHT. LINE ALONG THIS EDGE
- STRAIGHT
- EDGE
- THERE SHOULD BE NO GAP HERE WHEN SQUARE IS FLIPPED OVER TO DOTTED POSITION
- IN-RIP SCALE ON RIGHT SIDE OF ARM
- OUT-RIP SCALE ON LEFT SIDE OF ARM
- INSTALLING CONTROL CUT DEVICE
- SWITCH AND SWITCH KEY
- CAUSES OF KICKBACK
- AVOIDING KICKBACK
- RIP CUT HAZARDS AND PRECAUTIONS
- CUTTING LONG WORKPIECES
- NON-THROUGH CUTS
- LASER GUIDE
- LASER GUIDE
- NOTES
- 1-800-4-MY-HOME
- 1-800-827-6655
- DJUSTMENT