Maintenance, Engine – Sears 536.885410 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

MAINTENANCE
ENGINE
LUBRICATION
Check the crankcase oil level (See Fig, 17) before
starting the engine and after each five (5) hours of con-
tinuoususe. Add S,A.E. 10W-30 motor oil or equivalent.
Tighten the fill cap/dipstick securely each time you check
the oil level, S.A E 5W-30 motor oil may be used to make
starting easier in areas where the temperature is consis
tently 20° F, or lower.
Change the oil after the first two hours of operation and
every 25 hours thereafter or at least once a year if the
snow thrower is not used for 25 hours. (See Fig., 18).
®
Position the snow thrower so the oil drain plug is the
lowest point on the engine. Remove the oil drain
plug and oil fill cap/dipstick Drain the oil into a suit
able container. The oil will drain more freely when
warm.
® Replace the oil drain plug and tighten securely.
Refill the crankcase with S A E. 10W-30 motor oil
(or equivalent). S,A E 5W-30 motor oil may be
used to make starting easier in areas where the
temperature is consistently 20° F. or lower,
SPARK PLUG
® Make sure the sparkplug is tightened securely into
the engine and the spark plug wire is attached to the
spark plug
® If a torque wrench is available, torque the plug
between 18 and 23 foot pounds.
® Clean the area around the spark plug base before
removal to prevent dirt from entering the engine.
®
Clean the spark plug and reset the gap periodically,
15