Lighting, Warning – Sears 153.33535 User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Lighting

WARNING

BEFORE

LIGHTING

[PROPANE

(L.P.)

GAS

WATER

HEATERS]:

Propane

(L.P.)

gas

is

heavier

than

air.

Should there be a leak in the system, the gas will settle
near

the

ground.

Basements,

crawl

spaces,

skirted

areas

under

mobile

homes

(even

when

ventilated),

closets and areas below ground level will serve as
pockets

for

the

accumulation

of

this

gas.

Before

attempting to light or relight the water heater's pilot or
turning on a nearby electrical light switch, be absolute­
ly sure there is no accumulated gas in the area. Search
for odor of gas by sniffing at ground level in the vicini­
ty of the appliance. If odor is detected, follow the steps
indicated at "For Your Safety" on the cover page of
this manual, then leave the premises.

Lighting and operating instructions are located on front of
the water heater, above or to one side of the gas control
valve.

■ WARNING

AN ODORANT IS ADDED TO THE GAS USED

BY THIS WATER HEATER.

FOR YOUR SAFETY
IF YOU SMELL GAS:
1. Do not try to light any appliance.

2. Do not touch any electrical switch; do not use any

f

ihone in your building.

mmediately call your gas supplier from a neighbor's

phone. Follow the gas supplier's instructions.

4. If you cannot reach your gas supplier, call the fire

department.

-WARNING

DO NOT force the gas control knob. Use only your

‘•own to light the pilot, or to turn it to

ON , "OFF" or "PILOT". Never use a tool such as a

№wr, wrench or pliers. Do not hit or damage the knob.
A damaged knob may result in an explosion and seri­
ous injury. If you have problem turning the knob, call
me gas supplier immediately.

CHECK FOR LEAKS

Be sure to check all your gas pipes for leaks before light-

B yp'“' water heater. Use a soapy water solution, not a

niUf •

flame. Check the factory gas fittings after

Thp and gas control knob is still in "PILOT" position.
"OM" PI

fittings when the main burner is turned

'N • Use a soapy water solution for this, too.

Figure 6

Jk

Figure 7

Figure 8

INNER

DOOR

Figure 9

OUTER

DOOR

15

Advertising