Fig. 6, Assembly – Sears 917.249491 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
4
MOUNTING TO TRACTOR (See Fig. 5)
Use Hardware - - GROUP "C"
NOTE: For ease of assembly, you may wish to obtain the
assistance of anothef person for mounting assembly to
tractor.
•
Raise seat on tractor to allow assembly to be mounted.
•
With cover closed, fift assembly and place support post
inside mounting bracket. Allow assembly to rest on
lanced tabs of mounting bracket.
» Line up holes in mounting bracket with holes in support
post and insert bracket support pin. Secure with re
tainer spring.
•
Unlatch and open cover,
•
Install the three {3) tubing end caps onto container
support.
“
Tap each end cap onto container support tubes to seat
securely.
5
CONTAINER ASSEMBLY (See Fig. 6)
No hardware required
0
Place bottom half inside of top half, as shown .
" Place one foot inside bottom half and lift top half to meet
bottom half.
•
Press halves tightly together while lifting top to lock into
place as shown.
IMPORTANT:
BEFORE LOCKING THE TABS, HOOKED
EDGES ON BOTH HALVES MUST OVERLAP TO FORM
SEAL AS SHOWN IN INSET
•
Repeat for second container .
ASSEMBLY CHECK: Squeeze sides of lower half of con
tainer and check that there is no gap between upper and
lower halves. If a gap appears, unlock tabs to separate
container halves and repeat instructions above.
i, ('
/
Fig. 6
8