Care of humidifier tank (continued), Bi-weekly maintenance, End of season maintenance – Sears Kenmore Quiet Comfort 758.144120 User Manual

Page 8: Care of fi iter, Care of filter, Of humidifier tank (continued)

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

.Care

of Humidifier Tank (continued)

Bi-Weekly Maintenance

Removing Scale

1.

Partially fill the water reservoir with one 8oz. cup of

undiluted white vinegar. Let solution stay 20 minutes.

2. Clean all interior surfaces with soft brush. Dampen soft

cloth with undiluted white vinegar and wipe out the
water reservoir to remove scale.

3.

Rinse thoroughly with clean warm water to remove

scale

and

cleaning

solution

before

disinfecting

the

reservoir.

Disinfecting Reservoir
t.Fill

water

reservoir

and

add

5

teaspoons

chlorine

bleach (1 teaspoon chlorine bleach in 1 gallon water.)
Let solution stay 20 minutes, swishing every few min­
utes. Wet all surfaces.

2.

Empty water

reservoir after 20 minutes. Rinse with

water until bleach smell is gone. Dry with clean cloth or
paper towel.

End of Season Maintenance

1.

Follow

bi-weekly

maintenance

instructions

at

end

of

humidification

season

or

when

humidifier

will

not

be

used for at least one week or more.

2. Remove and throw away filters.

-3. Let humidifier dry completely before storing. Do not

store with water inside water reservoir.

4. Store in cool, dry location.
5. Install new filters and clean humidifier before next sea­

son begins.

Care of Fi iter

Dry out the unit completely before changing filters. (See
Cleaning of Humidifier Tank).

1. Unplug the electrical cord.

2.

Before removing the filters, we recommend moving the

humidifier to an area where floor coverings are not
susceptible

to

water

damage,

i.e.

kitchen

or

bath

areas.

3. Remove the lid completely from the unit by closing and

lifting up from the hinge holders.

4. With one hand on each side of the motor support sec­

tion, lift straight up and set gently on the floor in an

upright position..

WARNING: Be sure the humidifier is unplugged or
the fan may come on after the motor support sec­
tion is removed from the tank.________________

5. The filter is enclosed in a filter holder. Lift out the entire

holder to gain access to the filter.

a.

To replace filter, remove used one from plastic

holder by gently pushing from the side, insert a new

filter in the filter housing.

b. To clean filter, lift out filter holder, leaving dirty filter

in the holder. You can either dry oJffilter or leave
wet. Place filter and holder under cold tap water on
medium pressure and rinse. Not all of the dissolved^
solids will wash off of filter, but this procedure will

restore filter to a more efficient condition. Another

way to clean filter is to completely submerge filter in
a bucket or sink full of clean cool water and dip

repeatedly.

6.

Replace the filter (in holder) in the humidifier tank by

lining up rear slot on filter holder frame with track on
tank. Tilt holder toward rear and lower until front tab
lines up with front slot on the filter holder. (See Figure

14)

7. The filter holder sits on a float located at the bottom of

the tank.

8.

Pick up the motor support section and, while standing

over the tank, locate the tabs that the support section
sits on. Be sure the electrical cord is lined up with the

rear opening, and gently slide the motor support sec­

tion down into the tank.

9.

Replace the lid and follow the filling and operating

instructions.

FILTER HOLDER

FILTER

FILTER TRACK

FLOAT

Figure 14

Advertising
This manual is related to the following products: