Installing motor pulley – Sears 113.21371 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
9. Gently push down on the FEED HANDLES until the
head raises upwards as far as it will go.
10. TIGHTEN THE HEAD LOCK HANDLE AND THE
QUILL LOCK HANDLE.
11. HOLD onto the Feed Handle and UNLOCK the quill
lock handle.
12. Let the quill return to the UP position in the head.
13. TIGHTEN THE QUILL LOCK HANDLE,
Repeat
steps
3
thru
10
until
the
head
is
raised
to
the
desired
position.
Position
HEAD
SUPPORT
COLLAR
underneath the head and tighten the bolts.
CAUTION; Do not raise the head above the top of the
column.
INSTALLING MOTOR PULLEY
When using a double shaft motor, remove the KEY from
the 5/8 in. dia. shaft.
1.
Using
a
5/32
in.
setscrew
wrench,
UNSCREW
the
setscrew
in
the
pulley
so
that
it
is
clear
of
the
KEYWAY (GROOVE).
2.
Place
the
pulley
on
the
shaft.
Make
sure
it
slips
on
EASILY
.
.
.
don't
FORCE
it.
Remove
any
burrs
in
the
pulley or on the shaft if any.
3.
Position
the
pulley
so
that
the
KEYWAYS
in
the
shaft
and
in
the
pulley
line
up;
and
the
small
end
of
the
pulley is about 1/16 of an inch away from the motor.