To remove mower (see fig. 19), To install mower (see fig. 19), Service – Sears EZ3 917.256543 User Manual
Page 20: Amd adjustments
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SERVICE
AMD ADJUSTMENTS
A
/ o
CAUTION: BEFORE FERFORMINO ANY SERVICE OR ADJUSTMENTS:
Depress ciutch/brake pedal fully and set parking brake.
Place gearshift lever in neutral (N) position.
Place attachment clutch in “DISENGAGED” position.
Turn ignition key “OFF” and remove key.
Make sure the blades and all moving parts have completely stopped.
Disconnect sparkplug wire from spark plug and place wire where It cannot come in contact with
plug.
.
TRACTOR
TO REMOVE MOWER (See Fig. 19)
Mowerwill beeasierto remove Irom the right side of tractor.
» Place attachment clutch in “DISENGAGED" position.
Move attachment lift lever forward to lower mower to its
lowest position.
Roil belt off engine pulley.
Disconnect clutch rod from clutch ievet by removing
retainer spring.
Disconnect anti-sway bar from chassis bracket by
removing retainer spring.
Disconnect suspension arms from rear deck brackets
by removing retainer springs.
Disconnect front links from deck by removing retainer
springs.
Raise lift lever to raise suspension arms. Slide mower
out from under tractor.
IMPORTANT:
IF AN ATTACHMENT OTHER THAN THE
MOWER
IS
TO
BE
MOUNTED
TO
THE
TRACTOR.
REMOVE THE FRONT LINKS.
TO INSTALL MOWER (See Fig. 19)
" Raise attachment lift lever to its highest position,
» Slide mower under tractor with discharge guard to right
side of tractor.
“ Lower lift lever to its lowest position.
" Install mower in reverse order of removal instructions.
FIG
I
i