Sears Kenmore 625.348234 - Manual (Page 17)

SECTION 3
CARE OF YOUR FILTER
3D. BEFORE YOU CALL FOR SERVICE ... HELPFUL HINTS CHECKLIST
PROBLEM CAUSE CORRECTION
FILTER WILL NOT BACKWASH Manual bypass valve(s) in bypass
position See FIG. 8. page 18. Move stem In a
single bypass valve to SERVICE. In a
3-valve bypass, open the inlet and outlet
valves, close the bypass valve.
Transfomer unplugged at wall outlet, power
cable disconnected, fuse blown/circult
breaker popped, or circuit switched off Check for loss of power and correct.
Resetthe times and use the BACKWASH
NOW feature . . . see page 9. Also see
"Electric Power Outlet For Your Filter,
page 17 in the installation manual.
Timer In the vacation (VAC) position Press the VACATION button once to
return the fllterto service... see page 9.
Timer not programmed for backwash See page 8 to program a weekly sched­
ule.
An error code shows in the face plate
display See page 9.
Backwash flow washer plugged See key No. 38, page 26, and remove
drain hose adaptor to clean.
Drain hose plugged, kinked or bent Straighten hose, or remove and clean.
LOW WATER PRESSURE AT HOUSE
FAUCETS Well pump pressure switch set too low Adjust to a minimum of 20 psi.
Backwash needed more often to keep
filter mineral clean
See page 8 to program more backwashes.
FILTERED WATER CONTAINS SEDI­
MENTS, IRON, DIRT, SAND, ETC. See all conditions under Filter Will Not
Backwash, above.
NEUTRALIZER FILTER ONLY: FILTER
WATER IS ACID OR PARTLY ACID
Manual bypass valve(s) In bypass
position See above.
NOTE; Filter low on neutralité mineral Add new mineral... see page 14.
Trace plumbing to be sure faucet(s) is on
filtered water service.
TASTE & ODOR FILTER ONLY:
FILTERED WATER HAS BAD TASTE
AND/OR ODOR
NOTE;
Manual bypass valve(s) in bypass
position See above.
Activated carbon mineral bed is exhausted Replace mineral,.. see page 16.
Trace plumbing to be sure faucet(s) is on
filtered water service.
17