How to stop your cleaning system, Siphoning, Tips – Sears 580.768050 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Move Run/Stop switch to the “Run” position.
Press the primer bulb three (3) times, waiting two
(2) seconds between each push.
• Grasp starter handle and pull slowly until you feel
some resistance. Then pull cord rapidly to
overcome compression, prevent kickback and start
the engine. Let rope return to starter slowly.
Note: The Pressure Command™ may be placed in
any position during starting or operation. However, for
cold starts, it is recommended that the Pressure
Command™ be placed in the “high" position.
Note: If the engine fails to start after 3 pulls, prime the
engine three (3) times and pull starter rope again.
■ Once the engine has started, disengage the spray
gun safety latch.
HOW TO STOP YOUR CLEANING SYSTEM
•
Move the Run/Stop switch to the “Stop” position.
•
Simply shutting off the engine wilt not release
pressure in the system. Squeeze trigger on the
spray gun to relieve pressure in the hose.
Note: A small amount of water will squirt out when
you release the pressure.
•
Rotate the Dial-A-Cleaner™ selector knob to the
OFF position to prevent chemical leakage.
SIPHONING
DO NOT siphon standing water for your water supply.
Contaminated, brackish or dirty water can damage the
pump. Connect only to household water supply.
TIPS
•
Never use the garden hose inlet to siphon
detergent or wax.
•
If you hold the spray nozzle too far away from the
object being cleaned, washing will not be as
effective.
• Always store the cleaning system wiUi №e DiaF
A'Cleaner™ selector knob to the OFF position.