Canon MP 190 Pixma - Manual (Page 62)

58 Troubleshooting
The Document Cover Comes Off
Scanning Problems
„ ScanGear Won’t Start
„ Other Scanning Troubles
Refer to the Scanning Guide on-screen manual.
Cause Action
The Document Cover was opened too
hard. If the Document Cover is opened too hard, it may come off. Reattach it
according to the following procedure.
(1)Insert the protrusion on one side of the Document Cover hinge into the
holder.
(2)Hold the middle of the Document Cover and press down above the second
protrusion as shown in the figure below to reattach the Document Cover.
Cause Action
The scanner driver (ScanGear) is not
installed. Follow the procedure described in your setup sheet to reinstall the MP Drivers.