Sears 200.71488 User Manual

Page 5

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

To operate a 12V DC device:

1. Open the protective cover of the DC

power outlet on the front panel of the

Portable Power 1150.

2.

Plug the 12V DC device into the DC

power outlet, and turn on the 12V DC

device (if required).

3.

If both 12V DC devices combined

draw more than 30 amps, the fuse will

blow. To replace, contact a qualified

service technician.

4. Charge the Portable Power 1150 as

soon as possible after each use.

Because the DC power outlet is in­

ternally wired directly to the internal

battery, extended operation of a 12V

DC device may result in excessive

battery drain.

12V DC ELECTRICAL DEVICE EXAMPLE RUN-TIME CHART

Appliance Type

Fluorescent Lights, Cellular Phones

Radios, Depth Finders, Fans

Camcorders, DVD Players, Spotlights

Electrical Tools, Bilge Pumps

Electric Coolers

Air Compressors, Car Vacuums

Estimated Wattage Estimated Time*

4 Watts

9 Watts

15 Watts

24 Watts

48 Watts

80 Watts

50 Hours

25 Hours

13 Hours

7.3 Hours

4.5 Hours

2 Hours

*NOTE: Estimated run-times. Actual time may vary. Times are based on the internal

battery being fully charged.

AIR COMPRESSOR, INFLATOR AND DEFLATOR

USING THE AIR COMPRESSOR

CAUTION: Read instructions of the
product being inflated before using the

compressor. Avoid over inflation, do not
exceed the manufacturer’s recommended

pressures. Do not leave the air compres­

sor unattended during use.

1.

Remove the air compressor hose

from the storage compartment in the

back of the Portable Power 1150.

2. Attach the air compressor hose to the

product or accessory to be inflated by

flipping down the lever.

3. Push the air compressor switch to the

ON position and inflate product.

4.

When the product is inflated to the

proper air pressure, push the com­
pressor switch to the OFF position

and remove the hose.

5. Do not run for more than 10 minutes

maximum at a time. If you do, allow

the 1150 to cool down for 10 minutes

before using again.

NOTE: If the compressor overheats, the

built-in thermal protection will turn the
unit off. Wait a few minutes and it will

automatically restart.

NOTE: The air compressor is rated for

150 PSI.

ESTIMATED TIME FOR INFLATING

6 to 24 minutes

Vehicle Tires

13” to 16”

Bike Tire

Sports Balls

1 to 3 minutes

30 seconds

Use the air compressor gauge to ensure

the proper pressure has been reached.

Do not over inflate.

USING THE INFLATOR

CAUTION: Read instructions of the prod­
uct being inflated before using the inflator.

Avoid over inflation, do not exceed the

manufacturer’s recommended pressures.

Do not leave the inflator unattended dur­

ing use.

Advertising